LTP Stoneseal Stone Tile Sealer (250ml Aerosol)

LTP Stoneseal is a tile sealer that forms a colourless barrier and helps to protect porous stone surfaces from water, dirt, oil, grease, soot and lime scale. LTP Stoneseal makes treated surfaces easier to keep clean. It offers the ideal protection for polished and unpolished natural and artificial stone. LTP Stoneseal is ideal for limestone, marble, travertine, slate, sandstone, quartz, terrazzo, basalt, concrete and all other types of masonry surface. And, it can be used both indoors and out!

LTP Stoneseal is idea for stone fireplaces, worktops, and stone (both polished and unpolished). It's easy to apply thanks to it's aerosol dispursion and and protects against all types of dirt and grease.

Directions for use:

Always use a mask. Use in well ventilated areas.

Preparation:
Areas to be treated must be cleaned. Older contaminated and dirty stone surfaces should be cleaned with LTP Stoneclean intensive foaming cleaner and then rinsed thoroughly. Newly installed surfaces should be clean and free from dust before application.

Rough cut, tumbled, textured or riven surfaces:
Shake can well. Hold can 15-20 cm from the surface and spray in a sweeping motion. Touch dry within 5 minutes. Test area 30 minutes after application with a little water. If the water is absorbed, a second or even third coat of LTP Stoneseal may be required to obtain maximum performance. A 2-3 hour curing time is recommended upon completion before allowing traffic.

Honed, smooth and polished surfaces:
Shake can well. Hold can 15 to 20cm from the surface and spray in a sweeping motion. Leave for up to 5 minutes and then remove visible excess with an absorbent cloth. Finish after removal of excess by buffing with soft lint free cloth or machine with buffing pad. Do not allow residues to dry on the surface.

Notes:
Do not spray LTP Stoneseal on to painted, acrylic or stained surfaces such as cabinets and stained timber skirting boards. Mask and protect these surfaces before application. Use only in open or well ventilated areas. It is recommended that a suitable respiratory mask be worn at all times. Overspray on most surfaces will dissipate however on some surfaces it may leave a slight residue. This should be wiped up within 5 minutes. Stubborn residues left on the surface can be removed with the application of more LTP Stoneseal which should then be buffed off immediately. For wet areas including shower enclosures and wet rooms allow the sealer to cure for a minimum of 24 hours before use. Always test the product on an inconspicuous area for suitability before general application. Shake can well before use.

Coverage:
Per 250ml : 5 – 10 m² depending upon the porosity and the number of coats required.

Storage:
Store in a cool, dry, frost-free environment.

Click the links below to see the technical specifications and user guides for this product.

• Click here to see the LTP Stoneseal Technical Data Sheet